Update

 

 

Chip Xilinx XC95288XL

June  2010 : CTPCI_1E

Replace CTPCI_1C with following features :

            - PCI zone extended to 2*1GB (no EtherNAT use).
            - TEAP output added for PLX DMA anti-freeze.

April  2010 : CTPCI_1C

Replace CTPCI_1B with following features :

- Activation of the IEO output pin for EtherNAT. 

April  2010 : CTPCI_1B

Replace CTPCI_1A with following features :

- Modification of the TA signal timing for better stability.

- Change of I6 output and INT registers.

 

Initial version  - January 2010 : CTPCI_1A

 

 

 

 

 

To program the chip, you can contact me or buy a JTAG cable to transfer from // port to the chips.

This cable exists ready-to-use to many vendors. It will not run as it is on TOS machines.

Here are 2 links to buy (you can find many others) :

FRANCE : http://www.lextronic.fr/recherche.php?rech=jtag&numpage=10

CANADA : http://www.renaelectronics.com/product_x_cable.htm

 

 

Two ways :

 

 

1- Program with a PC

 

 

PC software is available free to www.xilinx.com. The name is IMPACT and you will find it in the WEBPACK to be downloaded. 

 

The good link to help you with PC, software & cable : http://nokturnal.pl/home/atari_16_32_bit/ct60_firmware_upgrade

You need too to reorganize the order of the wires on the JTAG  connector as on the schematics or pinout in the CT60 documentation (in the software pack). 

 

 

 

 

2- Program with the Falcon

 

 

To run the cable on your Falcon,  you need to modify it : disconnect the wire of pin #13 & connect to the pin #10 of the DB25 connector. You need too to reorganize the order of the wires on the JTAG  connector as on the schematics or pinout in the CT60 documentation (in the software pack). 

 

Other way : make the cable yourself.

Schematics of the cable for TOS (PDF) : Download ZIP file (15 KB). PC version schematics is on Xilinx web site.